PURE-AIR, industrial laser smoke purifier, more than ten years of concentrated product development and manufacturing, direct supply from the manufacturer, reject the price difference between the middlemen!

1. After the Industrial laser smoke purifier is turned on, the centrifugal fan runs, and dust removal and smoke removal begin to work. The smoke and dust caused by laser cutting enters the air inlet of the dust collector under the driving force of the centrifugal fan exhaust. Special attention is that this Laser cutting dust collector equipment is equipped with a high-efficiency exhaust fan, with large exhaust air volume and high negative pressure, which can complete powerful dust removal, and there is no way to escape from the smoke and dust in the production workshop!

2. Sparks and dust are the most advanced to the spark catcher. The sparks are automatically extinguished after several impacts and fall into the silo of the industrial laser smoke purifier.

3. Then it enters the surface of the filter cartridge. Because the cross-section of the cyclone suddenly expands and the effect of the cyclone spreading over the plate, the wind force drops sharply. Some of the thick particles in the cyclone collide with each other under the effect of the wind driving force and the moment of inertia, and of course the foundation settles to the bottom. Aggregate bin; fine particles with fine particle size distribution and low relative density are accumulated on the outer surface of the filter cartridge filter material and blocked according to the composition effects of spreading and microporous filtration. Because this industrial laser smoke purifier uses high-quality nano-technology flame-retardant filter materials, while ensuring the safety factor, it also gives strong characteristics, which can make the smoke and dust purification treatment efficient to achieve 99.7%.

4. After filtering, the clean vapor passes through the filter material, is discharged from the inner cavity of the filter cartridge, and enters the clean room.

5. The gas in the clean room is then drawn out by a centrifugal fan and discharged. The smoke and dust pollutants that are intercepted during filtering are covered on the surface of the filter material and slowly accumulate. Another highlight of this laser cutting dust collector equipment is that it is equipped with a fully automatic single-pulse reverse blowing ash removal system software, which can open the air compression to perform automatic gas generator ash removal on the filter cartridge, and reasonably increase the filter cartridge. The service life of the dust collector ensures the working efficiency of the dust collector, and promotes the manpower removal and maintenance cost of the machinery and equipment to be greatly reduced!

If you want buy fume extractor, please contact with Dongguan Pure-Air Tech Co.,ltd, E-mail: sales@pure-airtech.com.