Laser welding smoke extractor, mobile dust extraction equipment is a professional dust removal equipment for purifying smoke and dust in the welding process. Practice has proved that the dust collector adopts a qualified welding fume filter for dust removal and filtration. The dust content in the atmosphere is only 3~4mg/m3, which is not only in line with the current environmental testing standards. Due to the obvious improvement in the air quality in the workshop, this kind of fume welding machine has always been favored by front-line workers.

Mobile welding fume extractor, laser welding soldering fume extractor first uses the suction generated by the wind to purify the fume and then sucks the welding fume into the dust collector. Since the air containing dust flows in the filter and the dust is filtered out, whether the welding fumes can be sucked into the welding fume purifier is the key to its purification. However, in the process of use, occasionally the smoke will be exhausted and smoking is not allowed. What are the causes of it? Below, I will give you a brief introduction.

When the filter screen filters smoke and dust, large particles of dust will fall on the lower ash hopper, and small particles of dust will adhere to the surface of the filter screen. The accumulation will form a dust layer and block the filter holes, thereby affecting the air flow of the welding fume purifier. Traffic jams result in reduced air volume, and smoking is not allowed. This is inevitable, and it is inevitable to inject the filter element regularly through the pulse cleaning device to remove the dust. But as time goes by, the filter element will still be completely clogged and needs to be replaced at this time. However, if the strength of the dust removal equipment can be maintained within a certain period of time, it can be replaced once a year.

The welding fume collection box is not well sealed, which will cause gas leakage.

Mobile welding fume dust removal equipment, the connection between the box and the accessories of the mobile dust suction equipment is not completely closed, air leakage will occur during the operation of the equipment, and the air cannot reach the suction port, so the flue gas cannot be collected naturally. This kind of thing rarely happens, and it is entirely a quality problem of the manufacturer, and the user can request a free replacement.

In short, the main reasons why laser welding smoke filter cannot inhale smoke are the large welding smoke, low fan power, clogged filter element, and poor sealing. Therefore, when using the welding fume purification device, these factors must be fully grasped in order to improve the efficiency of the equipment.

If you want buy fume extractor, please contact with Dongguan Pure-Air Tech Co.,ltd, E-mail: sales@pure-airtech.com.