Small dust collectors, filter cartridge fume extractor, and other smoke
purification equipment manufacturers believe in environmental protection
technology. Next, I will introduce some problems and technical problems
encountered during polishing.
Grinding and polishing personnel must be trained and pass an exam to obtain
a job certificate before they can be employed;
Clarify the process requirements, materials and initial state of the
workpiece, the processing position, shape, size and polishing accuracy
requirements of this process; before polishing, you must check: whether the
polished surface has sags, sags, overcuts, deformations, blisters and other
defects , And whether the polishing margin is sufficient; according to the
process requirements, properly protect the workpiece; re-confirm the step and
enter the operating program.
For high or long workpieces below 20Kg, it is required to clamp the
polishing table with a vise; for larger and heavier workpieces, they must be
fixed with magnets and screw clamps before and after the polishing table; use a
work cart When grinding and polishing the workpiece, wedges must be used or
relevant measures must be taken to ensure the work is firm and safe; for the
workpiece with small contact surface and easy to be bruised or bumped, rubber
sheet must be used to protect the surface; the workpiece has For sharp corners
and corners, tape or tape should be used to protect them to prevent personal
injury or damage to the workpiece; for workpieces that need to maintain the edge
and sealing position, a baffle (saw blade or Iron sheet) or baffle to protect
the anti-edge and chamfer.
Check the content and scope carefully, whether there are corners or rounds
on the sealing surface; whether the inclination of the original mold is damaged;
check the size of each polished surface to determine whether it exceeds the
reserved size; whether there are rounded corners at the bottom of the cavity The
side and bottom of the depression; whether there is an inversion; whether the
roughness meets the requirements of the drawing;
The above is some of the information known in the industry by the
manufacturers of small vacuum cleaner and filter cartridge dust collectors of
Pure-Air factory.
If you want buy fume extractor, please contact with Dongguan Pure-Air Tech
Co.,ltd,