Industrial dust explosion-proof dust collector should meet the following requirements:

In the unified production process, the system should be integrated not far from the dust point.

Secondly, for different types of dust, different dust mixing recovery methods can be used in the processing process, and an independent recovery system can also be established, without the need for recovery costs.

For dust and gas with large temperature and humidity changes, the wind may condense after mixing, and the system should be installed separately.

When designing the industrial dust explosion-proof dust collector, the following issues should be carefully considered.

Do not have too many exhaust points in the exhaust system, which helps to balance the resistance of each branch. If there are too many exhaust pipes, a large cross-section collecting pipe can be used to connect the branch pipes. The flow rate of the header does not exceed 3 meters per second.

Secondly, in order to avoid dust deposits in the pipeline, the pipeline of the dust removal system should be as vertical or inclined as possible. The angle between the inclined pipe and the inclined plane should be greater than 45 degrees. To a certain extent, it must be exported.

Dust collection system pipes generally use small-diameter ring-shaped pipes with high wind speed. However, in order to prevent clogging, the diameter of the dust collection tube shall not be less than the following data.

The piping of the water purification system needs a good hydraulic balance. Hydraulic calculations can be used for parallel pipes. In the same total air system, the pressure difference between the two pipes must not exceed 15%, and the pressure difference between the two pipes of the dust removal system must not exceed 10% to ensure that the air volume of each pipe meets the design requirements.

In addition to affecting the economics of the system, the duct wind speed of the dust removal system should also consider factors such as excessively large pipes to accelerate equipment configuration and piping wear, excessively small piping dust accumulation, and piping blockage. In order to prevent dust and pipe clogging, the pipe wind speed must not be lower than the low air volume in the table below.

Industrial Dust explosion-proof dust removal system should pay attention to the following matters in actual work.

In addition, in the workshop of a pharmaceutical factory, due to the many dust removal points, long pipe time, large number of pipes, and long pipe time, the dust removal effect is affected. Therefore, it is very necessary to install a dust removal equipment adjustment room near the dust collection point.

If conditions are limited, other dust removal methods such as mobile vacuum cleaners or direct recycling exhaust systems can be recycled, and the part that produces a small amount of dust is directly squeezed out of the room.

Secondly, in order to ensure the normal operation of the dust removal system and prevent secondary pollution, the dust under the dust removal pipe should be treated. The management principle is to remove secondary pollution, gradually become a treasure, and improve economic efficiency.

According to the production process conditions, the quality of dust removal, the cost of recycling, the amount of dust removal, on-site recycling, and comprehensive waste treatment methods.

If you want buy fume extractor, please contact with Dongguan Pure-Air Tech Co.,ltd, E-mail: sales@pure-airtech.com.