For a plastic mold factory, it takes time to complete a set of mold billing time and labor, among which smoke and dust fill the entire workshop, resulting in a decrease in production efficiency. PURE-AIR laser cutting smoke extractor effectively purifies the smoke and dust pollution of the plastic mold workshop!

What method is used to purify the dust in the plastic mold factory

Activated carbon adsorption is a reasonable countermeasure to remove the peculiar smell of water, pure natural and generate melted organic matter, micro-environmental pollution components, etc. Most of the relatively large molecular structure of organic matter, ester compounds, halogenated alkyne, etc. can be firmly adsorbed on the activated carbon On the surface or in the crevices, it has a significant practical effect on removing humus, organic matter and low molecular weight organic matter. Activated carbon adsorption is used as a deep purification processing technology.

The structure and characteristics of the laser enfraving air filter equipment of the purification plastic mold factory

The key components of laser fume extractor filters equipment are: centrifugal fan, gas filter, activated carbon (or chemical fiber) adsorption tower, such as steam recovery and utilization also need to be equipped with coolers, separation equipment, such as carbon fiber material recycling also need to be equipped with steam, hot air boiler Wait. Water vapor is used for adsorption to complete the adsorption of organic waste gas in the carbon fiber material. After desorption, the organic solvent and water vapor enter the cooler for cooling, and are separated by the separation equipment to obtain a clean organic solvent. After desorption, the activated carbon fiber in the filter cartridge should be dried with warm air before being used again.

If you want buy fume extractor, please contact with Dongguan Pure-Air Tech Co.,ltd, E-mail: sales@pure-airtech.com.